front wheel alighnment.

[hillbilly]

anyone got detailed pics with measurements,of the front wheel spindle spacers on a z1 900.thought they might be the same,but my front wheel is out of line.onlyfour mill but the twin brake calipers wont go in together.

[KeithZ1R]

are the bearing out or in to the shoulders suffered the same problem with a rear wheel drove me insane till i spotted it obvious I know but somtimes wood for trees

[hillbilly]

bearings are ok,ive even tried a h1500 front spindle,gona afta get the grinder out me thinks. the first one was an a1/2 front axle,but found out that they are wider across the bottom.

[Taffus]

check the speedo drive is located properly

[hillbilly]

now this might be right or it might just be me clutching at straws,but i have the top triple tree off a z1,the bottom triple tree might be an a1/2,are the z1000 yokes wider than a z1.

[bigmac103]

same thing happened to me a while ago and Taffus has a very good point! It certainly was my problem.

[london calling]

I've got a Z900 A4 bottom yoke if you need it
FOC just cover the postage

[hillbilly]

thanks jack,i think i will have a measure up first to see if it is my problem,will be in touch.

[hillbilly]

got it today jack,thanks again,ps,send me your address then i can send you the postage.its only fair.

[hillbilly]

maybe not to clear,but the ruler was touching both sides of the yolk on one side,and the other end was deffinately out a fair bit.problem solved,cheers jack.