Going slowly at the moment

Fitted battery box & electrics. Coz I've swapped me bare Z900LTD frame for the Z1000A1 frame, some of the fittings are different. The battery box does fit OK on the front mounting plate, linked to the engine mount, bit has no fixings nearest the rear wheel.
I have fitted a couple of 'rubbers' (snigger) and it rests snuggly on the frame close to the rear inner fender.
Note: I'm still thinking about fitting the standard seat
As I'm gonna fit lower bars I had to strip switchgear electrics off the standard bars. To my horror I realised the switchgear cable is routed through the handlebars, to conceal the wires
It took a good half an hour, but I managed to get the cable out, damage free

The standard bars are slightly bent anyhow
Next hassle was trying to fit the switchgear to the non-standard bars
Coz the original bars have holes for the cables, the switchgear housings sit flush alround on the bars. As they do NOT have cut outs for the cable to pass through, I had to use me DREMEL to cut out slots for the cable.
And on the 7th day... Zeds were created!