Cush drive rubber

[scott]

Anyone know where I can find a brand new Cush drive rubber for a z1000a2

[z1bman]

THIS WORKS OUT TO ABOUT £80

http://www.bikemaster900.de/shop/produc ... ts_id=8472

[scott]

Unfortunately it looks sold out too

[scott]

I presume that one off a z650b1 would be too small?

[Ginger Bear]

Scott,

Do you have spoked or cast wheels?

[z1bman]

you could glue some rubber ( old inner tube ) to the sides of the driving dog's on the sprocket coupling

[scott]

Steve, It's a spoked wheel.....I know Zpower do one for the cast wheel.....and I've found one for z650 but I presume it's too small?......I could glue some rubber on as a last resort but would prefer to find a new one, that would last me for my lifetime

[Ginger Bear]

Pretty rare then. part No. 42014-028 (As I'm sure you're already aware) is only listed as being common to these three models;


KZ1000-A1 (KZ1000) (1977)
KZ1000-A2 (KZ1000) (1978)
KZ1000-A2A (KZ1000) (1978)

[Ginger Bear]

Try here

http://www.speedsupplies.com/parts/kawa ... 14-028.htm

[scott]

Nice and rare, yes. I've got a second hand one coming, might be better than mine, we'll see....might take me a while to find a NOS one

[scott]

That one states that it is obsolete.....I've found one or two advertised but when you get to the checkout they state obsolete there's got to be one somewhere

[snotie1965]

Steve, It's a spoked wheel.....I know Zpower do one for the cast wheel.....and I've found one for z650 but I presume it's too small?......I could glue some rubber on as a last resort but would prefer to find a new one, that would last me for my lifetime

The "inner tube" trick works fine ! my gpz11 ut has it done at present , and has not cost a penny ! all you are doing is taking up 1 or 2 mm of slack due to wear ?

[scott]

Cheers snotie, if all else fails that is what I will do.

[RGH]

http://www.ebay.com.au/itm/Kawasaki-Rea ... 3cdd9f5504

[scott]

Thanks for that Ross, it's in the post...skippy's bringing it