Hello Guest User,
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
choke jet
Moderators: KeithZ1R, chrisu, paul doran, Taffus
Do you mean the long brass tubes that go to bottom of float bowl??
If so I use steel guitar strings to pass up the centre hole and clear it out.
They won't snap off and block it (unlike wire brush bristles !!!)
You need to use the top e string which is just one wire and the thinnest in the set.
Teenagers are a good source of used guitar strings if you are struggling or you can buy a top e on it's own cheap enough.
Hope that helps
From Mark
If so I use steel guitar strings to pass up the centre hole and clear it out.
They won't snap off and block it (unlike wire brush bristles !!!)
You need to use the top e string which is just one wire and the thinnest in the set.
Teenagers are a good source of used guitar strings if you are struggling or you can buy a top e on it's own cheap enough.
Hope that helps
From Mark
Z1-R D1, Z650 B2, Z1-B & ZRX 1200 A1P Catch 'em if you can at www.Zedrider.co.uk
It's a different set up, it doesn't have the long brass tube but a pressed in jet next to the mains and pilot. Last night I did use a wire brush strand, lucky it didn't, your right we have a kids guitar I could have robbed.
They were absolutely solid choked, the bike had had a carb clean from the garage that commissioned it but the missed the pressed in choke jet. It had only done 900 miles from new between 1986 mad 2011,
Good advice on the wire choice!
They were absolutely solid choked, the bike had had a carb clean from the garage that commissioned it but the missed the pressed in choke jet. It had only done 900 miles from new between 1986 mad 2011,
Good advice on the wire choice!
Who is online
Users browsing this forum: No registered users and 15 guests