Jumbo wrote:If you look towards the start of this page:-
http://pic5.piczo.com/z900/?g=5845840&cr=5
There is a picture of the forks in bits, it comes from a fellow member from Australia.
good link!
Thanks
Hello Guest User,
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
FORK SEAL REPLACEMENT
Moderators: KeithZ1R, chrisu, paul doran, Taffus
FORK SEAL REPLACEMENT
New seal fiitted, broom handle worked well(thanks to Pigford) used rounded end pinch bar which i covered with a piece of thick rubber car heater hose to stop damage to alloy on fork when levered old seal out.Thanks to all for their advice on this next job on Z1 b is to start to refit head to engine when it comes back after its had new valve guides fitted.
PAULJAC47,,,,,"She may not look like much, but she's got it where it counts, kid."
-Han Solo
You can't polish a turd, but you can roll it in glitter
Salad is what real food eats.
Anon
PUM 673
-Han Solo
You can't polish a turd, but you can roll it in glitter
Salad is what real food eats.
Anon
PUM 673
Who is online
Users browsing this forum: No registered users and 14 guests