Hello Guest User,

Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.

To access these 'Registered Users Only' areas simply register and login.

Re-torquing Cly Hd?

Need help restoring, building, or finding then try here.

Moderators: KeithZ1R, chrisu, paul doran, Taffus

Post Reply
Message
Author
sprint
100Club
100Club
Posts: 284
Joined: 14th Oct 2014
Location: Eastbourne

Re-torquing Cly Hd?

#1 PostAuthor: sprint » Mon Aug 31, 2015 2:31 pm

When I rebuild my A4 earlier in the year, April, I torqued the cylinder head nuts and bolts to 30 ft-lbs and 10 ft-lbs respectively.

Have done around 4K miles since then and have removed the cam cover to check the valve clearances.

Just out of interest I checked a few of the nuts and the end bolts with the torque wrench and found that I could tighten them up?

There are no leaks of any kind so the question is is this normal for these composite head gaskets, rather than the solid copper ones I'm used to on the old brit bikes, used on these bikes? Gasket set came from Z- Power, so should be OK.

Never see anything about re-torquing Jap bike cylinder heads so should I just leave alone or should I do a full re-torquing?
Top
User avatar
zed1015
Hardcore
Hardcore
Posts: 2319
Joined: 2nd Nov 2005
Location: Somewhere between Scunny and Goole.

#2 PostAuthor: zed1015 » Mon Aug 31, 2015 2:43 pm

You should have re-torqued after the first heat cycle and then at around 500 miles.
So Yes! you should re-torque.
Top
Gavin
Custard Cream
Custard Cream
Posts: 792
Joined: 11th Jun 2011
Location: Scunthorpe

#3 PostAuthor: Gavin » Mon Aug 31, 2015 6:47 pm

zed1015 wrote:You should have re-torqued after the first heat cycle and then at around 500 miles.
So Yes! you should re-torque.


Cheers Rob
I have done mine after its first rideout but didn't know about the 2nd time.
Image


Cheers
Gavin
Top
Post Reply

Return to “Bike Help”

Who is online

Users browsing this forum: No registered users and 14 guests