oil leak from tacho drive

john · #1 PostAuthor: **john** » Fri Aug 21, 2015 8:00 pm

Hi Lads
Z1B any one havesany ideas about tacho drive leaking oil . Changed both seals which did not seem to make any difference . Would you know if l need a new worm drive or the complete unit holder and drive . Thank you , kind regards
John

z1bman · #2 PostAuthor: **z1bman** » Fri Aug 21, 2015 8:06 pm

worm gear probably has grooves in it where the seal has rubbed replace it. give the holder a coat of sealant before you put it back in the engine use a fibre washer from the z650 to seal between the cable & the tacho drive

john · #3 PostAuthor: **john** » Sat Aug 22, 2015 10:03 pm

Great ,Thank you for that .
Kind regards John

kev edwards · #4 PostAuthor: **kev edwards** » Sun Aug 23, 2015 6:25 pm

Best thing to do is buy new seals a worm gear from Zed power cheap enough, anything else is just a temporary repair.

z1bman · #5 PostAuthor: **z1bman** » Sun Aug 23, 2015 6:31 pm

fibre washer for tacho cable part no 92065-103

scott · #6 PostAuthor: **scott** » Mon Aug 24, 2015 6:51 am

I had the same problem....replaced the worm drive and its been fine since

ZedHead · #7 PostAuthor: **ZedHead** » Mon Aug 24, 2015 8:57 am

http://www.saisei-europe.com/Shop/Produ ... o-ring-kit

timhb · #8 PostAuthor: **timhb** » Mon Sep 14, 2015 8:25 am

I have a similar problem on my Z1b and need to replace.

There were several options here on the forum and just wondered if sorted and if so which route you took john ?

There was a link for seals to the Sansei site although a z650 fibre washer was also advised?

Did you replace the worm drive also from Z power?

cheers