This new gasket was barely 1mm thick before fitting, The old original after being fitted still measures 1.8 mm. Anyone know where to get one of these old originals from, this never leaked, Oh and I have torqued it down correctly 
Hello Guest User,
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
SHi*e rocker cover gasket
Moderators: KeithZ1R, chrisu, paul doran, Taffus
SHi*e rocker cover gasket
Hi Guys, anyone help. Not long ago did the valve clearances decided to put a new rocker cover gasket on I purchased it off the Net. when you run the bike up now "Smokes like a 1960's chip shop" from the top of the engine. Edge of the gasket bubbling and weeping all around. This new gasket was barely 1mm thick before fitting, The old original after being fitted still measures 1.8 mm. Anyone know where to get one of these old originals from, this never leaked, Oh and I have torqued it down correctly
This new gasket was barely 1mm thick before fitting, The old original after being fitted still measures 1.8 mm. Anyone know where to get one of these old originals from, this never leaked, Oh and I have torqued it down correctly 
Sit the cam cover on the head without the gasket and check for a gap between the gasket faces.
It's common for some covers to sit on the cam cap bolt heads instead of sitting directly on the head and these will not tighten fully on to the thin gaskets.
You just end up clamping the cam cover on to the top of the cam cap bolt heads.
You will still need a thicker gasket but your present leaks may not be the fault of the gasket itself.
If this is the case it's possible to spot face the inside of the cover to give some clearance for the bolt heads and then your thin gasket should be able to do it's job.
It's common for some covers to sit on the cam cap bolt heads instead of sitting directly on the head and these will not tighten fully on to the thin gaskets.
You just end up clamping the cam cover on to the top of the cam cap bolt heads.
You will still need a thicker gasket but your present leaks may not be the fault of the gasket itself.
If this is the case it's possible to spot face the inside of the cover to give some clearance for the bolt heads and then your thin gasket should be able to do it's job.
Who is online
Users browsing this forum: No registered users and 16 guests