Hi all after some advice
Just had the bike mot after a strip and rebuild not touched the engine
I purchased the bike and striped it before I had done any miles on it,
On start up I look like a blue arrow for about 30 seconds out of the top right hand exhaust then it clears
I think the valve oil seals need replacing
Can I do this with out taking the head off and is it a easy job
Apart from that I am really pleased with my first Z
Hello Guest User,
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Smoking
Moderators: KeithZ1R, chrisu, paul doran, Taffus
It possible to change the seals without head off by rope or flex in the cylinder to hold valve up or by compressed air into the plug hole,not a big deal really to wip the head off anyway,dont be tempted to use nasty seals out of pattern gasket set use gen or viton...
PAULJAC47,,,,,"She may not look like much, but she's got it where it counts, kid."
-Han Solo
You can't polish a turd, but you can roll it in glitter
Salad is what real food eats.
Anon
PUM 673
-Han Solo
You can't polish a turd, but you can roll it in glitter
Salad is what real food eats.
Anon
PUM 673
Who is online
Users browsing this forum: No registered users and 13 guests