I want to check the needle position on my standard Z1000A1 carbs. Can I remove the slides without removing the carbs?, ie will 2 & 3 foul on the frame tubes?.
Also, any tips on removal/refitting of the connecting rod to get the slides out/in?.
Ta.
Hello Guest User,
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Slide Removal....
Moderators: KeithZ1R, chrisu, paul doran, Taffus
Slide Removal....
ʎɐqǝ uo pɹɐoqʎǝʞ ɐ ʎnq ı ǝɯıʇ ʇsɐן ǝɥʇ sı sıɥʇ
Hi Gaz it is possible, just saw through frame tubes and reweld when done,hope this helps 
What you playing at anyroad ? spanners? just give it a polish
What you playing at anyroad ? spanners? just give it a polish
PAULJAC47,,,,,"She may not look like much, but she's got it where it counts, kid."
-Han Solo
You can't polish a turd, but you can roll it in glitter
Salad is what real food eats.
Anon
PUM 673
-Han Solo
You can't polish a turd, but you can roll it in glitter
Salad is what real food eats.
Anon
PUM 673
tlc wrote:Garry.
They are on the middle position.
Cheers Chris.....
If they are on number 2/3 then the problem is not the needles......
I'm defo thinking fuel starvation or lean/weak mix as if I l lift the choke on the flat spot the revs pick up cleanly, also the plugs are looking a little white.
ʎɐqǝ uo pɹɐoqʎǝʞ ɐ ʎnq ı ǝɯıʇ ʇsɐן ǝɥʇ sı sıɥʇ
Who is online
Users browsing this forum: Google [Bot] and 16 guests