battery charging

[z1bman]

1 check the alarm fuse
2 check batteries in remote
3 press + hold both buttons for 5 seconds
4 re program your remote
5 replace the pcb at a cost of about £100

[jimmock]

1 check the alarm fuse
2 check batteries in remote
3 press + hold both buttons for 5 seconds
4 re program your remote
5 replace the pcb at a cost of about £100

Done the checks yesterday,

Fuse OK, Both fobs seem to be working good, stripped it down to "drain" after a "Spike", pressed both buttons several times in several combinations (both thumbs are sore today!!).

The problem is that it does not bleep and flash to disarm. I can crank over with NO ALARM at all. If I shake it the alarm and indicators go off. If I untape the seat micro switch the alarm goes off.

When I press the fob I can hear the box clicking inside.

I think I have a buggered black box????

[jimmock]

1 check the alarm fuse
2 check batteries in remote
3 press + hold both buttons for 5 seconds
4 re program your remote
5 replace the pcb at a cost of about £100

Done the checks yesterday,

Fuse OK, Both fobs seem to be working good, stripped it down to "drain" after a "Spike", pressed both buttons several times in several combinations (both thumbs are sore today!!).

The problem is that it does not bleep and flash to disarm. I can crank over with NO ALARM at all. If I shake it the alarm and indicators go off. If I untape the seat micro switch the alarm goes off.

When I press the fob I can hear the box clicking inside.

I think I have a buggered black box????

Guyz,

After reading my post ...........


I suppose it would be worse if I had a buggered back door!!!

[z1bman]

yes 99% sure your pcb is shot you don't have to remove the complete alarm if you want to get it running just remove the pcb + short across the emobolized wires on the two block connectors if you want to know how + which wires to short let me know + i will send you a pm

[jimmock]

yes 99% sure your pcb is shot you don't have to remove the complete alarm if you want to get it running just remove the pcb + short across the emobolized wires on the two block connectors if you want to know how + which wires to short let me know + i will send you a pm

Z1Bman is a LEGEND.

He sent me a PM with a pic.

BLADE IS NOW RUNNING!!!!!

I owe Z1Bman a couple of "sexual favours" !!!!

[jimmock]

Just back in from my virgin ride on the 'Blade!!!!


BRAW!!!!