Hello Guest User,
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Smooth bore what jets,clip setting
Moderators: KeithZ1R, chrisu, paul doran, Taffus
Smooth bore what jets,clip setting
I am getting ready to install a set of 29 mm smoothbores with pods to the z. The bike is stock except for a V&H 4 into 1. I have a friend who insist I put the needle on the #4 clip and run 120 main jets. Is this Ok ?? Your opinions will be helpfull.Thanks gregz
Z1
1965 Corvette
1965 Corvette
-
Jeff Saunders
- 100Club
- Posts: 337
- Joined: 18th Nov 2004
- Location: Upstate NY, USA
- Contact:
Do you know what the 29's came off? If they came off a Suzuki, then the slides may have 2.0mm cutaway versus the 1.5mm normally found on the zeds.
Assuming you have the 1.5 slides, I would normally start with 120 main jets, 20 pilot jets, needle clip in the middle (number 3 position) and the air screw 1 1/4 to 1 1/2 turns out.
#4 clip setting is a little rich and it will probably be a little too rich for a stock setup with V&H pipe.
Assuming you have the 1.5 slides, I would normally start with 120 main jets, 20 pilot jets, needle clip in the middle (number 3 position) and the air screw 1 1/4 to 1 1/2 turns out.
#4 clip setting is a little rich and it will probably be a little too rich for a stock setup with V&H pipe.
73 Z1 (turbocharged), a 74 Z1A, and some h***a's and Suzuki's...
www.z1enterprises.com jeff@z1enterprises.com
www.z1enterprises.com jeff@z1enterprises.com
Who is online
Users browsing this forum: No registered users and 11 guests