Hello Guest User,
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Fork brake lugs need cutting back !!!!
Moderators: KeithZ1R, chrisu, paul doran, Taffus
Revision - I would mill loads off that if I was you!!
the wood work one has the wrong cutting angles. The HSS ones may grab and self feed - apart from that £75 for a one off job is a bit much.
I assume you are going to mount the adaptor plate on the outside.
If you are good with a file and marking out then you could always just cut a bit off and file it parallel to the other lug. If you have a nice flat piece of steel clamp the fork leg to it, so the tops of the mounts are parallel to the plate, clamp another piece of steel to the plate which is the same height as the lugs and use that as a guide to file to.
the wood work one has the wrong cutting angles. The HSS ones may grab and self feed - apart from that £75 for a one off job is a bit much.
I assume you are going to mount the adaptor plate on the outside.
If you are good with a file and marking out then you could always just cut a bit off and file it parallel to the other lug. If you have a nice flat piece of steel clamp the fork leg to it, so the tops of the mounts are parallel to the plate, clamp another piece of steel to the plate which is the same height as the lugs and use that as a guide to file to.
Rich
diplomacy is a form of art - I was never any good at art
diplomacy is a form of art - I was never any good at art
Who is online
Users browsing this forum: No registered users and 14 guests