Hello Guest User,
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
starter clutch
Moderators: KeithZ1R, chrisu, paul doran, Taffus
-
noelmcguinnessz900
starter clutch
i have just taken a good starter clutch out of one engine and put it in an other which had a dodgy one but looking at the dodgy one i cant see anything that looks worn or broken can anybody tell me what i should be looking for any help appreciated cheers noel
Noel,usually the two main things to look for are:
1. that the 3 spring loaded rollers are smooth with no grooves, flats or sign of slipping.
2. the ground surface, on which these rollers run on, should also be as above and have no chatter marks.
Note: It only take a slight imperfection to cause these to mal-function.
More serious problems are where the rotor has come loose on the taper and where a small approx 6mm pin has broken inside the rotor, or the three large Alan-headed bolts have come loose. Also, check the round washer damper that is there, to put a little friction on the large gear wheel, so that it doesn't rattle.
RegardZ.
1. that the 3 spring loaded rollers are smooth with no grooves, flats or sign of slipping.
2. the ground surface, on which these rollers run on, should also be as above and have no chatter marks.
Note: It only take a slight imperfection to cause these to mal-function.
More serious problems are where the rotor has come loose on the taper and where a small approx 6mm pin has broken inside the rotor, or the three large Alan-headed bolts have come loose. Also, check the round washer damper that is there, to put a little friction on the large gear wheel, so that it doesn't rattle.
RegardZ.
Garn (Sydney) Z1, Z1A, Z1B and Z900-A4
Who is online
Users browsing this forum: No registered users and 27 guests