Thanks chaps, im getting there............
Si
Hello Guest User,
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Bleeding Brakes
Moderators: KeithZ1R, chrisu, paul doran, Taffus
-
martinz1000r
- Custard Cream
- Posts: 955
- Joined: 1st Jul 2007
- Location: Oxfordshire
The best way to bleed brake or clutch lines when completely drained of fluid is a progressive approach through the system. Make sure the reservoir is topped up and the pump the pedal about 5 times. Get someone to hold the pedal down whilst you loosen the union on the brake pipe closest to the reservoir/master cylinder. Make sure you have a rag around it to catch any fluid. Tighten before the pedal is released. Repeat this and then move to the other end of the pipe and do it again. Continually ensure the reservoir is topped up.
By doing this you will clear air right the way through and may not even need to touch the bleed nipple which can from experience seize in the calliper.
Works for me every time and it will take 5 minutes to have a rock hard pedal. Works for brakes and hydraulic clutches. No need to muck about with little gadgets.
By doing this you will clear air right the way through and may not even need to touch the bleed nipple which can from experience seize in the calliper.
Works for me every time and it will take 5 minutes to have a rock hard pedal. Works for brakes and hydraulic clutches. No need to muck about with little gadgets.
Z1000R, Moto Martin, z900 A4 Crosby Replica, Harris Magnum 2, Suzuki GSXR 1100 Slabbie, Yamaha YZF750SP, SP1 Hoonda, Katana 1100, Bimota SB6R
Who is online
Users browsing this forum: No registered users and 16 guests