hi all goin to be fitting the vesrah head gasket on my z1a does it fit any way round cos the steel rings are round on both sides but one side looks flatter.
cheers
Hello Guest User,
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
vesrah head gasket
Moderators: KeithZ1R, chrisu, paul doran, Taffus
KeithZ1R wrote:the side with the flats on the copper washers goes down im told ...cue derision
Yep slighty domed copper uppermost!
PAULJAC47,,,,,"She may not look like much, but she's got it where it counts, kid."
-Han Solo
You can't polish a turd, but you can roll it in glitter
Salad is what real food eats.
Anon
PUM 673
-Han Solo
You can't polish a turd, but you can roll it in glitter
Salad is what real food eats.
Anon
PUM 673
ogre wrote:might av been a bit premature between my first post and keithz1r reply cos i think i fitted them the other way round i have put a very thin layer of hylomar on both sides cud it be ok or is it a strip and start again.
It's not "end of the world" and should be okay..... just depends how anal you are. Its a gasket and is compressed equally both sides, by similar flat metal surfaces. I'd give it a go and not sweat it
although I'm sure someone will be along to condemn my answer as sh*te 
PS: Hope it's not BLUE hylomar, needs to be high heat resistant.
And on the 7th day... Zeds were created!
Who is online
Users browsing this forum: No registered users and 15 guests