Offset drive sprockets

[mayhem]

Hi,

Wondered if anyone out there can help. I have a B1 GPz1100 chop which I have just hardtailed and during this we fitted a rear wheel off a ZZR1100 rear wheel. I now have the problem of lining up sprockets etc. Some of the adjustment will be taken up by machining down the outer face off the sprocket carrier/cush drive at the back end but due to the width of wheel etc Iwill need to make up some of it at the front sprocket as well. Does anyone out there know of an easy cure or perhaps supplier of offset sprockets for these beasties. I will be puttin pics of the rebuild etc on site for anyone thats interested

Cheers

Mayhem

[phil churchett]

I am certain Debbens do off-set sprockets.

http://www.debben.co.uk/

[mayhem]

wikkid mate cheers

[Pigford]

Debbens stock loads of 'em.... or try Talon in Yeovil

[mick znone]

ok mayhem, put some pickies up when you can, welcome to the site

[Redbeard]

Welcome along mayhem, i'd love to see some pics of this chop mate.

[london calling]

I'm pretty sure that the ZZR1100 front sprocket has an offset as standard and are readily available to check for chain run clearance.
The ZZR is probably a 530 size,so the thinner chain should help.
Large offset sprockets put extra load on the output shaft.

[mayhem]

I have the ZZR sprocket but it has no offset at all

[mayhem]

prob not rite place to post this but can someone recommend a site i can put some pics so i can get them onto here

[phil churchett]

There is a thread in "Discussion Board" on how to post pics.
You will need a Photobucket account, which is free.

http://photobucket.com/