Hello Guest User,
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Wanted Z1B Parts
Moderators: KeithZ1R, chrisu, paul doran, Taffus
-
z1bnackerkwacker
- Custard Cream
- Posts: 690
- Joined: 20th May 2006
- Location: Swansea
Wanted Z1B Parts
Wanted Z1b 900 parts, rear wheel spindle complete with nut/ washers, spacers and tensioners, not sure if I need swinging arm pivot spindle as well (j.m.c fitted) never really looked if standard is used, will check that out tomorrow...
-
paul doran
- Area Rep.
- Posts: 15910
- Joined: 24th Sep 2004
- Location: near Dublin Ireland
-
z1bnackerkwacker
- Custard Cream
- Posts: 690
- Joined: 20th May 2006
- Location: Swansea
Spindle
Thanks Paul, none this way, only sheep, will check tomorrow if any bits are standard or jmc, I bought a standard swinging arm years ago, but it's bare, want to fit my centre stand but can't due to braced jmc, I have toyed with idea of cutting brace off, may be a bit drastic tho, thanks again, Andrew....
Finally getting my arse round to a bit of Zed work, not sure if swinging arm pivot is standard, think wheel spindle is J.M.C........
Finally getting my arse round to a bit of Zed work, not sure if swinging arm pivot is standard, think wheel spindle is J.M.C........
Who is online
Users browsing this forum: No registered users and 12 guests