I'm hopefully getting round to fitting the cylinders and cylinder head this weekend and could do with some advice on the gaskets/O rings.
Cylinders to crankcase gasket, clymer manual suggests some gasket compound around the centre studs but does not say if this is crankcase or cylinders side or both, any suggestions as to what's best?
Cylinder head to cylinders, I've been supplied a one piece gasket with the Wiseco kit, should I use this instead of the genuine two piece and separate centre oil seal?
Cylinder O rings, the manual picture is pretty grainy but appears to describe the four red O rings being installed onto the base of the liners, and the gasket being installed on the crankcase before lowering the cylinders down the studs, is this correct?
Hello Guest User,
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Gasket advice
Moderators: KeithZ1R, chrisu, paul doran, Taffus
Who is online
Users browsing this forum: No registered users and 17 guests