Just starting to get the bits together for my Z1A .Could any of you guys tell me the width and rise of a set of original Z1 high bars.
Thank's
Hello Guest User,
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Handle Bar dimensions
Moderators: KeithZ1R, chrisu, paul doran, Taffus
Roger, getting the exact replica's is not easy.
There is usually three or more dimensions to consider.
Dia of tube, width of bars, rise and pull-back.
I think the "rise" on the standard bars for the Z1 and Z1A is 5 inches. I understand the Z1 B did have an option of lower bars.
The rise is critical because of its effect on the length of clutch and throttle cables.
Have a check through the usual Z1 part catalogs/ sites. They may nominate the "standard" bars. Kawasaki does still make them at a co$t....$$$$!
RegardZ.
There is usually three or more dimensions to consider.
Dia of tube, width of bars, rise and pull-back.
I think the "rise" on the standard bars for the Z1 and Z1A is 5 inches. I understand the Z1 B did have an option of lower bars.
The rise is critical because of its effect on the length of clutch and throttle cables.
Have a check through the usual Z1 part catalogs/ sites. They may nominate the "standard" bars. Kawasaki does still make them at a co$t....$$$$!
RegardZ.
Garn (Sydney) Z1, Z1A, Z1B and Z900-A4
Who is online
Users browsing this forum: No registered users and 15 guests