Z1OwnersClub GB

Hi guys i have been offered a Metmachex swinging arm, the seller thinks its for the z1000 but wont commit to it,
so my questions is does anyone know the width it needs to be i.e. wheel spindle width and swinging arm pivot bolt, i need to know the gap for both so i can see if he is right as i have my doubts,
any help would be great , thanks all
kind regards Phill

i have one with z1000 on it,it fits no problem on my z1 900 frame,pics on hillbillys z1 rebuild.

firstly Phil it should have Z1000 stamped on it where the spindle fits in btween the frame
it is usually located on top and is usually clearly stamped

thanks all, im going to get some dimensions from my zr2 swinging arm and ask him the same from his and fingers crossed,
thanks again
Kind regards Phill