Page 1 of 1
Cam bearing cap bolt torque settings
Posted: Mon Mar 30, 2009 11:26 am
Author: Steve R
Cam bearing cap bolt torque settings, I think I read somewhere the torque settings in the book were not correct?
Is this right, what should they be?
Posted: Mon Mar 30, 2009 11:44 am
Author: chrisu
steve,
it depends on the bike. The Z900s are lower.
Posted: Mon Mar 30, 2009 3:00 pm
Author: Steve R
Hi Chris,
Its a z1a with 1015 barrels and head , Now bored out to 1075
So I guess its the figures for a z1000 that would be appropriate!
Posted: Mon Mar 30, 2009 3:14 pm
Author: Padders
I have always gone with 7ft/lbs as per Z900 recommended settings. Cannot see why/if there is a differance between Z900 and Z1000.
Posted: Mon Mar 30, 2009 5:25 pm
Author: DogsbolloxofZ1B
69in/lbs will suffice.
Posted: Wed Apr 01, 2009 2:11 pm
Author: PAULJAC47
Had one shear at 7 pounds!! guess it may have been cracked bolt rest were ok.....