Z1OwnersClub GB

Posted: **Sat Feb 14, 2009 9:13 pm**

i have a 1976 Z1000 engine, will a 92 Zephyr 1100 head (dual plugs) fit ?

Posted: **Sat Feb 14, 2009 10:06 pm**

Hi...... Don't rightly know.... but I'd put money on it that the answerws NO :evil:

Posted: **Sat Feb 14, 2009 10:08 pm**

would it not just need an APE conversion kit same as a gpz11?

Posted: **Sat Feb 14, 2009 11:44 pm**

Can APES build engines these days, fuckin el! I must be well out of the information circuit! :roll:

Posted: **Sun Feb 15, 2009 9:17 am**

hmm, so i will have to find out myself, picked one up cheap,
btw hello to everyone !
IÂ´ve been registered for quite a while now, as i have a Kwaka-engined Rickman that needs a serious overhaul, but time permitting, i did not start by now...
:roll:

Posted: **Sun Feb 15, 2009 10:10 am**

You could try asking Rob at Mistral Engineering
http://www.mistralperformance.com/
He's loves an old Zed and has a lot of knowledge. If he does not know, his ex partner John Carpenter should know.
Good luck,
Rod :wink:

Posted: **Sun Feb 15, 2009 10:32 am**

FJD wrote:i have a 1976 Z1000 engine, will a 92 Zephyr 1100 head (dual plugs) fit ?

This is gonna be velly interesting..... Be sure to keep us updated with your findings :wink:

Posted: **Sun Feb 15, 2009 10:57 am**

If it were possible and provided a benefit, my guess is that we would have already seen these conversions done many many years ago.

Posted: **Sun Feb 15, 2009 1:25 pm**

As far as I know nothing off the Zephyr engine fits the Zed engine as it was a total redesign - the GPz engines were a development of the early motors so that was why some bits could be made to fit. I'm sure Steve Debben will be able to give a definitive verdict on this when he looks in.

Posted: **Sun Feb 15, 2009 2:24 pm**

Magnum1 wrote:Can APES build engines these days, fuckin el! I must be well out of the information circuit!

Seems they can Magnum1, some have learned to type on forums, :ooer

keep your eyes peeled,you'll notice them, they talk siht :lol:

Posted: **Fri Feb 20, 2009 11:31 pm**

I am sure the studs are a different dimension apart. As Diesel has pointed out the cam guide wheels are missing so the cam chain drive would need to be re-engineered, another problem would be the combustion chamber volume which would require modifying. You would also need to fabricate an exhaust to fit as the ports are a different spacing. inlet ports are also different although you could fit the Zephyr carbs if they clear the Z tank, so the answer is it could be possible with lots of work, but I would ask why, 8 plugging the Z head is far simpler and a lot less expensive. Regards Steve

Z1OwnersClub GB

will a newer Zyphyr head fit the old Z1000 ?

will a newer Zyphyr head fit the old Z1000 ?

Re: will a newer Zyphyr head fit the old Z1000 ?