Page 1 of 1
frame brace or engine guard?
Posted: Fri Jan 23, 2009 10:07 pm
Author: kano
check this out i want one lol.
and apparently im not alone so is it
custom 1 off or a Japanese part?
anyone know?
Posted: Fri Jan 23, 2009 10:28 pm
Author: kano
so far 2 sets are required right murph!
any advances on 2?
bet pig will want a set lol.
Posted: Sat Jan 24, 2009 12:34 am
Author: gbh
I've seen those marketed as a frame brace here in Japan. I can only remember seeing them on GPZ's.
Posted: Sat Jan 24, 2009 8:36 am
Author: chrisu
you also see them on a lot of ZRXs as well..........
Posted: Sat Jan 24, 2009 12:55 pm
Author: Rich
Much too far in for an engine guard.
If you want to brace it there why not replace the rubber mounts with alloy blocks, mount the engine and ream the mounting holes for oversize engine bolts.
Posted: Sat Jan 24, 2009 1:39 pm
Author: gbh
Rich wrote:Much too far in for an engine guard.
If you want to brace it there why not replace the rubber mounts with alloy blocks, mount the engine and ream the mounting holes for oversize engine bolts.
Good point but you know what? that doesn't have the same bling appeal and the Jays just love to bling up their bikes.
Posted: Sun Jan 25, 2009 9:17 am
Author: Rich
gbh wrote:Rich wrote:Much too far in for an engine guard.
If you want to brace it there why not replace the rubber mounts with alloy blocks, mount the engine and ream the mounting holes for oversize engine bolts.
Good point but you know what? that doesn't have the same bling appeal and the Jays just love to bling up their bikes.
I think you could be right there
