Z1OwnersClub GB

I wonder if anyone can help ?

I,m doing up a unitrack gpz see here http://www.z1ownersclub.co.uk/forum/viewtopic.php?t=6653

Got it started today. It started fine but the ecu was flashing

It transpires that I have not got an air temp sensor.

does anyone have a photo and/or know a place I can get one from

thanks

Try posting the question on this site, the lads on here seem to specialize in GPz/injection/turbo stuff, and the like

http://www.oldskoolperformance.com/forum/index.php

Not to say one of our chaps won't have the answer

Thanks for the quick reply. I will give that site a go too

Is it the air temp sensor you are missing or the engine temp sensor ?
The engine temp sensor fits into a tapped hole between no1 and 2 inlet ports. Depending on which head you are using the hole might allready be tapped or it might just have the boss which you can drill and tap.
I might have a 750 Turbo engine temp sensor in my shed.

hi pasc

Its definitely the air temperature sensor I have found the connection in the wiring.

i should have one email your address and i will post it if i can find it (my shed is a shit hole) as one or two on the site have already noted

your a star

posted it today hope i works for you.

That little sensor sits on the top of the air box and can cause a load of problems if damaged or not fitted.The one on my B2 was open circuit and would run ok till warmed up,then run rich and was very hard to start when warm(because of running rich).Used a uni track ECU to fault find cause its got the LED light for code reading.Just my tuppence worth

big green bus wrote:posted it today hope i works for you.

thanks steve I got it yesterday I will be giving it a go in the week

Iain I thought it would be running rich without it, but wasn't sure how the ecu would cope


Thanks guys for all you help and input