Page 1 of 1
1100 carb inlet rubbers/manifolds
Posted: Thu Jun 05, 2008 6:47 pm
Author: cbxade
Hi,i have an 1170 gpz motor in my zed and i have a very nice set of Mikuni 36mm smoothbores to go on but i need larger inlet rubbers.They need to be 42mm bore.If anyone knows what will fit or where to get them from that would be great
Thanks
Ade
Posted: Thu Jun 05, 2008 7:26 pm
Author: Pigford
Pretty sure
www.z1enterprises.com do 'em
I thought the larger MKII/GPZ rubbers were about 40-42mm dia
Posted: Thu Jun 05, 2008 7:33 pm
Author: cbxade
Mmmm! I'll look into it
Ta very much
Posted: Thu Jun 05, 2008 7:38 pm
Author: Pigford
Posted: Thu Jun 05, 2008 9:24 pm
Author: Gus
I run a 1260 gpz motor with 36's and use stock 1100 inlets.
Debben do some but they won't fit the B1 without mod's see
here near the bottom of the page
Posted: Sat Jun 07, 2008 7:14 pm
Author: big green bus
zx6 ones fit strait on but they are about 20mm longer so if space is tight you may struggle but they fit 36's no bother and have carb balance take off,s too