Z1OwnersClub GB

howdy. any suggestions for holding my tank badges in place:The original screw threads have given up. I read somthing about velcro. Would this work ok? Tommy

Well it is a bodge but my screw holes are shagged aswell

So i used a double sided cloth tape i got from a carpet fitter, it is sticky as f..k hard to cut but once on it holds, my badges have been on over two eyars with no problems

There are other double sided tapes an things out there so have alook around

Gary

So gripper rods are no good then

3M do double sided tape. Alot of the car badges are held on by this

no crap at holding tank badges on, but they are great for keeping your arse firmly planted on the seat under hard acceloration