Page 1 of 1
Components location
Posted: Fri May 02, 2008 8:35 pm
Author: Robw
Hi, although I took some photo' s before I stripped it down, I missed the layout of the electrical bits around the battery carrier. The pictures in the Clymer book are a lot to be desired and I am not sure where the ICE unit goes, I have fitted it to the front of the battery carrier. So if someone could take a couple of photo's of the area, I would be very appreciative the bike is a Z1000R and either email me or put them on the post.
Thanks in advance
Rob
Posted: Sat May 03, 2008 12:02 am
Author: chrisNI
Is this what you wanted to see? Sorry about the cobwebs they're not standard fitment the bike's been sitting for nearly two years until the other night when I brought it round to the garage to pull the head off.
Posted: Sat May 03, 2008 4:48 am
Author: london calling
Rob,email me your postal address and I'll lend you a genuine workshop manual which has got several good pictures of the battery box area,etc.
Posted: Sat May 03, 2008 7:15 am
Author: Robw
Jack, cheers for that, would it be possible to take a photo of the front of the battery box as well. In the Clymer it shows that the ICE is either on the LH side or on the right next to the fuse box. I don't think I have lost any brackets but the only place mine sits is here
Cheers Rob
Another pic
Posted: Sat May 03, 2008 11:45 am
Author: chrisNI
Posted: Sat May 03, 2008 11:57 am
Author: Robw
Cheers Chris, right place just upside down, off to change it now.
Jack I will PM you
Cheers Rob
Posted: Sat May 03, 2008 12:00 pm
Author: london calling
No worries Rob
