Page 1 of 1
Clocks bracket
Posted: Wed Feb 20, 2008 8:19 pm
Author: RALPHARAMA
I am ready to fit the clocks bracket. It has the vestiges of some foam to support the instruments, which has long since rotted away, which would explain why the clocks were a tad wobbly.
Any known source of a suitable replacement foam? How thick should it be? There's no part number given in the book, so I guess there's no "off the shelf solution"
Posted: Wed Feb 20, 2008 9:23 pm
Author: z2.john
Kawasaki do list these foam bits
25019-025 , 25019-026, 25019-027 & 25019-028
Suspect they are NLA but have seen them on ebay from time to time
John
Posted: Thu Feb 21, 2008 5:49 pm
Author: Rich
Neoprene sponge and a stanley knife
Posted: Thu Feb 21, 2008 7:44 pm
Author: bedlow1
Originals seem to be NLA unless lucky to find on ebay, so a suitable alternative fix is door foam draught excluder tape from B & Q.
Posted: Thu Feb 21, 2008 7:59 pm
Author: phil churchett
Ralph, make sure you re-new the mounting rubbers too.
Posted: Thu Feb 21, 2008 11:14 pm
Author: Whatever
I have just cut some out of 2mm black neoprene and it is easy to cut and does the job nicely and will last forever.
If you want some then PM me your address I will put a piece in an envelope for you because I have a little left over. It also has self adhesive backing making it a piece of piss to 'fit'.
In the meantime you could cut some paper patterns out to make it dead easy to mark out the neoprene when it arrives.
Posted: Thu Feb 21, 2008 11:39 pm
Author: RALPHARAMA
That's very kind of you.
You have PM ... (unlike my missus who has PMT
groan - I'll read this all hungover tomorrow and regret what seems funny now
)
Posted: Fri Feb 22, 2008 10:01 am
Author: Steve S
Posted: Sat Feb 23, 2008 11:57 am
Author: RALPHARAMA
Many thanks Paul
Arrived this morning, I'm gonna run downstairs right away and fit it!
It'll be good therapy for my hangover!
Thanks Paul; you're a gent
Posted: Mon Feb 25, 2008 11:53 pm
Author: RALPHARAMA
I have just cut some out of 2mm black neoprene and it is easy to cut and does the job nicely and will last forever.
If you want some then PM me your address I will put a piece in an envelope for you because I have a little left over. It also has self adhesive backing making it a piece of piss to 'fit'.
In the meantime you could cut some paper patterns out to make it dead easy to mark out the neoprene when it arrives.
Many thanks for that. All fitted and works a treat.