Page 1 of 1
Z1 73
Posted: Sun Oct 30, 2016 5:20 pm
Author: geraldknight
Hi could someone tell me if any of the 1973 Z1 900s had tank badges about 186mm long with hole centres about 146mm. If not what is the thread used on the badge screws?. Also did that year have a steering damper?. Many thanks Gerald
Posted: Sun Oct 30, 2016 6:48 pm
Author: z1bman
early badges where 122mm long later ones z1a/z1b 185mm long
Posted: Sun Oct 30, 2016 6:59 pm
Author: wilsonsjw11
Tank badge screw;
Countersunk-M3 x 6 (Pt number 92012-003)
Regards
Steve
Z1 900 73
Posted: Sun Oct 30, 2016 7:22 pm
Author: geraldknight
Thank you very much for the information. Cheers Gerald
Posted: Sun Oct 30, 2016 7:40 pm
Author: Pigford
Steering damper was offered as an optional extra... the earlier triples had them; is there a bracket on the r/hand side lower headstock?
Posted: Sun Oct 30, 2016 7:58 pm
Author: wilsonsjw11
Pigford wrote:Steering damper was offered as an optional extra... the earlier triples had them; is there a bracket on the r/hand side lower headstock?
Bracket for the damper is on the frame and the other end fixes to the bottom steering yoke via an M8 clearance hole.
Regards
Steve
Posted: Sun Oct 30, 2016 9:46 pm
Author: geraldknight
yes there is a bracket & M8 hole to allow for a damper but i wasnt sure if it is meant to have one. Cheers