Hello Guest User,

Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.

To access these 'Registered Users Only' areas simply register and login.

Rotor remover

Need help restoring, building, or finding then try here.

Moderators: KeithZ1R, chrisu, paul doran, Taffus

Post Reply
Message
Author
roosterrs
Regular Poster
Posts: 32
Joined: 3rd Feb 2015
Location: Northants

Rotor remover

#1 PostAuthor: roosterrs » Mon Jun 06, 2016 7:54 pm

Does anyone know where can I buy a rotor remover and holding tool from?(to remove the rotor from the crank) Its for a GPz750A3.
Thanks
Top
User avatar
z1bman
Hardcore
Hardcore
Posts: 4227
Joined: 3rd Mar 2010
Location: WORDSLEY WEST MIDLANDS

#2 PostAuthor: z1bman » Mon Jun 06, 2016 8:09 pm

no need to use a holding tool bolt is 18mm x 1.5 thread pitch you can order a bolt from here or your local fasteners you would require one about 60mm long


http://www.ebay.co.uk/itm/M10-M12-M18-E ... ln64kR6SMA
Top
Mr Bump
100Club
100Club
Posts: 111
Joined: 30th Dec 2015

#3 PostAuthor: Mr Bump » Tue Jun 07, 2016 8:12 am

Try checking to see if the rear wheel spindle is the correct thread - it works on the 1100's - I can't remember if it does on 750's or not. That said, a bolt is probably less awkward to use than a gurt long spindle.

Olly
'In your twenties you think you are immortal, in your thirties you hope you are immortal, in your forties you just hope it doesn't hurt too much'

Lemmy
Top
johny brando
100Club
100Club
Posts: 139
Joined: 3rd Aug 2013
Location: australia

Re: Rotor remover

#4 PostAuthor: johny brando » Sun Jun 19, 2016 11:22 pm

roosterrs wrote:Does anyone know where can I buy a rotor remover and holding tool from?(to remove the rotor from the crank) Its for a GPz750A3.
Thanks



I cannot remember exactly what one i used ...maybe both are the same size & pitch ( Top Yolk centre/stem Bolt ) or Wheel spindle..... O yeh & put a largish ball bearing in between the 2 faces first before screwing in .......then pull it up & then give it a good clout with a Nylon headed hammer ...and tighten again & repeat . Cheers.
Top
johny brando
100Club
100Club
Posts: 139
Joined: 3rd Aug 2013
Location: australia

Re: Rotor remover

#5 PostAuthor: johny brando » Sun Jun 19, 2016 11:24 pm

johny brando wrote:
roosterrs wrote:Does anyone know where can I buy a rotor remover and holding tool from?(to remove the rotor from the crank) Its for a GPz750A3.
Thanks



I cannot remember exactly what one i used ...maybe both are the same size & pitch ( Top Yolk centre/stem Bolt ) or Wheel spindle..... O yeh & put a largish ball bearing in between the 2 faces first before screwing in .......then pull it up & then give it a good clout with a Nylon headed hammer ...and tighten again & repeat . Cheers.


ALL STOP !!!!! i just noticed GPZ 750 !!! on a 'Z1 Forum' can't help you then don't know anything about them !
Top
Post Reply

Return to “Bike Help”

Who is online

Users browsing this forum: No registered users and 15 guests