Up until Sunday I had a dancing electronic Tacho. Thinking there was a fault I bought another which did the same. Despite putting power directly from the battery in the prescribed manner there was definitely an internal issue.
Well, it's now settled down to a lovely smooth operation but reads at half the speed it should.
Question is can I double the signal to the Tacho in some way?
I'm using a full standard GPZ11 UT ignition.
Hello Guest User,
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Tacho input question.
Moderators: KeithZ1R, chrisu, paul doran, Taffus
Tacho input question.
Asphalt Cowboy
Phil Churchett award winner 2015
Phil Churchett award winner 2015
Presumably the tacho feed is from one coil?
You could feed from both coils which will double the pulses to the tacho.
You'd obviously need to put a diode in each feed line to stop the coils being powered through the common tacho connection.
WARNING this advice is from someone who's electronics training is a) theoretical and b) from the valve era
You could feed from both coils which will double the pulses to the tacho.
You'd obviously need to put a diode in each feed line to stop the coils being powered through the common tacho connection.
WARNING this advice is from someone who's electronics training is a) theoretical and b) from the valve era
Who is online
Users browsing this forum: No registered users and 17 guests