Valve guides/liners
Posted: Wed Feb 10, 2016 6:32 pm
Guyz any recomendations on good machine shop West Mids area for valve guides on a4 head,or liners in old valves,used Sepp b4,ok but do take a while?
Z1OwnersClub GB
Kawasaki's Air Coooled Big Fours
http://rtest.z1ownersclub.co.uk/phpBB3/
Valve guides/liners
http://rtest.z1ownersclub.co.uk/phpBB3/viewtopic.php?f=4&t=37487
Page 1 of 1
Posted: Wed Feb 10, 2016 6:56 pm
bit further south but Buzzard does a cracking job
Posted: Wed Feb 10, 2016 7:28 pm
chrisu wrote:bit further south but Buzzard does a cracking job
+1 on Buzzard
Posted: Wed Feb 10, 2016 7:28 pm
Posted: Thu Feb 11, 2016 2:56 pm
Paul,
On your doorstep
J Engineering Wolverhampton.
Regards
Steve
On your doorstep
J Engineering Wolverhampton.
Regards
Steve
Posted: Thu Feb 11, 2016 3:23 pm
wilsonsjw11 wrote:Paul,
On your doorstep
Regards
Steve
they only do two strokes
Posted: Thu Feb 11, 2016 3:31 pm
z1bman wrote:wilsonsjw11 wrote:Paul,
On your doorstep
Regards
Steve
they only do two strokes
PJ's made new liners and reconditioned the head on my Z1B 5years ago and it's still running superbly.
Posted: Thu Feb 11, 2016 3:42 pm
they did a rd400 crank & re bore fore me 2 years ago & i asked if they did any head work & crank rebuilding for a z1b & they said they only do two strokes ??
Posted: Thu Feb 11, 2016 3:45 pm
Phoned em up and they said 2 strokes only 
Posted: Thu Feb 11, 2016 3:51 pm
We can take them out the club's list of service providers then.
Regards
Steve
Regards
Steve
Posted: Thu Feb 11, 2016 7:11 pm
wilsonsjw11 wrote:We can take them out the club's list of service providers then.
Regards
Steve
are you sure it was them who did your head ? i cannot see them mentioned on the clubs useful links?
Posted: Thu Feb 11, 2016 8:21 pm
+2 Buzzard
Posted: Fri Feb 12, 2016 6:36 am
z1bman wrote:wilsonsjw11 wrote:We can take them out the club's list of service providers then.
Regards
Steve
are you sure it was them who did your head ? i cannot see them mentioned on the clubs useful links?
I think they are still listed in the Z1OC handbook.
They definitely made and installed the liners in the barrels...The head God knows.
Regards
Steve