Page 1 of 1
Z1000J ape tower drill jig
Posted: Mon Aug 24, 2015 7:09 pm
Author: slappa13
Hi everyone
Has anybody got a ape tower drill jig I can borrow, buy, or hire please, so I can fit the tower in my J head so I can use on my new zed project . Thanks Neil
Posted: Mon Aug 24, 2015 7:49 pm
Author: ADRIAN H
I think I have one ? Will have to check tomorrow morning when I can get in the garage. It's blocked in at the moment.
I assume you mean the jig that allows you to fit the top idler from earlier engines to a Z1000J head
Posted: Mon Aug 24, 2015 8:00 pm
Author: slappa13
Yes Adrian, I've got a ape conversion tower but you need a drill jig to fit, if you have one that would be brill. Thanks Neil
Posted: Wed Aug 26, 2015 3:12 pm
Author: ADRIAN H
slappa13 wrote:Yes Adrian, I've got a ape conversion tower but you need a drill jig to fit, if you have one that would be brill. Thanks Neil
I have looked through the shed, and could not find it. It must be in my garage, I will have a look through my boxes later on and let you know.
Posted: Wed Aug 26, 2015 5:03 pm
Author: ADRIAN H
I have located the jig and the drill bit that came with it - pics below. If you wish to buy it you may for £30 including post.
Or pm me your address and I will put in the post - I just ask that you please return when you have finished. Adrian
