Page 1 of 1
Dyna s
Posted: Thu May 21, 2015 9:57 pm
Author: Hasbeen
Ive never fitted one, is it easy?, also will the coils need to be changed?
Thanks in anticipation of replies.
Nick
Posted: Fri May 22, 2015 4:21 am
Author: Garn 1
Has been, I take it, you have a Z1 series..
Easy to fit. Coils should be > 3.5 ohms, the standard coils are around this.
You nearly always need to extend coil primary leads (black & green).
RegardZ
Re: Dyna s
Posted: Fri May 22, 2015 7:59 am
Author: becker
Hasbeen wrote:Ive never fitted one, is it easy?, also will the coils need to be changed?
Thanks in anticipation of replies.
Nick
Very easy
Standard coils should be ok.
Only 3 wires to connect - I created a small section of 3 wire loom to connect the original wires from under the tank to the Dyna. The Dyna should come with enough wire to join them somewhere safe behind the engine, rather than under it.
Follow the fitting instructions and you shouldn't have any problems.
Posted: Fri May 22, 2015 8:27 am
Author: ZedHead
Posted: Fri May 22, 2015 11:57 am
Author: Hasbeen
Thanks guys its for a 1000A1 (shudve said.........) looks like im gonna put my hand in my pocket again........
Appreciate the help as ever.
Nick
Posted: Fri May 22, 2015 12:16 pm
Author: Pigford
NB:
Make sure the low tension teminals are well insulated - they can touch/short on the support posts!
Also make sure the support posts are long enuff - don't wanna put strain on the coil body - they can crack
Posted: Fri May 22, 2015 12:54 pm
Author: Ginger Bear
Heat shrink works well.
