Today was a good day. The Asphalt Cowboy ran up for the first time. However, selecting the best of the 2 starters I have it is noticeably lazy. Spinning it up directly from a battery it all sounds good but I would suspect there is a problem within that means it doesn't have the power to spin the motor adequately.
I have seen an assembly which contains all the brushes and springs (genuine K) for sale at a reasonable cost.
I would appreciate any experience others have on rebuilding starters and their success in defeating a lazy starter motor.
Hello Guest User,
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Starter motor
Moderators: KeithZ1R, chrisu, paul doran, Taffus
Starter motor
Asphalt Cowboy
Phil Churchett award winner 2015
Phil Churchett award winner 2015
Could be a bad segment on the rotor,clean up well and test continuity between segments,clean care fully with sharp knife between segments,make sure brushes are good and making good contact...Paul J
PAULJAC47,,,,,"She may not look like much, but she's got it where it counts, kid."
-Han Solo
You can't polish a turd, but you can roll it in glitter
Salad is what real food eats.
Anon
PUM 673
-Han Solo
You can't polish a turd, but you can roll it in glitter
Salad is what real food eats.
Anon
PUM 673
That's very kind.
I do have one on my J if they are the same. I'm probably not in any rush as there are a couple of things holding me up at the mo.
Really it's experience of refurbishing I'm after and Paul J has some good suggestions. My first job was rebuilding starters so I'm familiar. It's just that these motors are so small I wondered if they are even worth doing.
Brush kit ordered now so at least I'll give it a go
I do have one on my J if they are the same. I'm probably not in any rush as there are a couple of things holding me up at the mo.
Really it's experience of refurbishing I'm after and Paul J has some good suggestions. My first job was rebuilding starters so I'm familiar. It's just that these motors are so small I wondered if they are even worth doing.
Brush kit ordered now so at least I'll give it a go
Asphalt Cowboy
Phil Churchett award winner 2015
Phil Churchett award winner 2015
-
Mark Tiller
- Area Rep.
- Posts: 1772
- Joined: 12th Jun 2011
- Location: Stewkley, Leighton Buzzard
Who is online
Users browsing this forum: No registered users and 18 guests