Page 1 of 1
1105 Liner fitting
Posted: Thu Apr 23, 2015 3:39 pm
Author: ZedHead
Does a 1015 cylinder block need to be bored out to fit an 1105 liner and piston kit? Outside diameter of the 1105 liner is 81.25 mm.
Posted: Thu Apr 23, 2015 3:44 pm
Author: Ginger Bear
1105 is the largest you can go with a standard liner, although some prefer to stop at 1075 as the wall of the liner is fairly thin around the bottom.
Didn't have any problems with this though at 1105cc.
Posted: Thu Apr 23, 2015 3:56 pm
Author: ZedHead
Now that is tasty
A customer of mine has a set of f*&^!£d barrels with Wiseco K1105 kit and liners fitted. The question is could he go back to standard? I suspect not if the block has been modified to take the 81.25 O.D liners.
Just want to be sure of what i am saying.
Posted: Thu Apr 23, 2015 4:02 pm
Author: Ginger Bear
Posted: Thu Apr 23, 2015 4:30 pm
Author: ZedHead
Thanks GB.
I think i got it
Posted: Thu Apr 23, 2015 7:07 pm
Author: Ginger Bear
Dave, I've got a set of 1015 barrels to 1105 (bores no good) but with standard 75.5mm liners. Has minor fin damage on one end. £20 posted if they're any good to you?
Pic's coming.
Posted: Thu Apr 23, 2015 7:15 pm
Author: Ginger Bear
Posted: Thu Apr 23, 2015 7:22 pm
Author: ZedHead
Cheers mate. As i said it is for a customer so he would be happy to pay. I will let you know.
barrels
Posted: Fri Apr 24, 2015 2:21 pm
Author: KWACKERZ1
GB, I'LL Have them if Dave does not want them please.
Posted: Thu Apr 30, 2015 8:27 am
Author: ZedHead
Thanks for the offer GB my customer has decided to take his big bore liners out to 74mm - 1135cc.
KWACKERZ1, looks like these could be yours
Re: barrels
Posted: Thu Apr 30, 2015 3:34 pm
Author: Ginger Bear
KWACKERZ1 wrote:GB, I'LL Have them if Dave does not want them please.
All yours then Phil.
PM me your addy again
& I'll get 'em packed up.
Posted: Thu Apr 30, 2015 4:19 pm
Author: KWACKERZ1
Thanks. will do.
