Page 1 of 1
Tyres for standard Z1
Posted: Thu Dec 04, 2014 3:58 am
Author: ROZZER
Anyone running either Avon Road Riders or Bridgestone BT45's on standard size wheels on Z1? If so what tyre pressures are you running with rider only and where did you get pressure info from?
I'm having handling isues on my current tyres (Continental Blitz) running on pressures in owners manual (28 front 32 rear), I think these may be too low for modern tyres but can't get any info. Looking to change tyres for either of above so pressure info and handling comments would be appreciated.
cheers
John
Posted: Sun Jan 18, 2015 9:09 am
Author: ROZZER
Come on fellas, someone must have some info on tyre pressures etc cos I known plenty of you have these tyres fitted - any info would be very much appreciated.
Posted: Sun Jan 18, 2015 9:45 am
Author: wilsonsjw11
Bridgestone BT45s-Front=36 Rear= 37
Regards
Steve
Posted: Sun Jan 18, 2015 9:48 am
Author: Pigford
I'd try anywhere from +30psi - upwards for both.
I prefer TT100's - Old Skool tyres for an Old Skool bike - not just coz they look proper
Posted: Sun Jan 18, 2015 10:48 am
Author: chrisu
there was a thread about this a while ago- definitely use higher pressures.
36/38 according to bridgestone themselves.
http://www.bridgestone.co.uk/moto/search-results-bike/?model=Z%20900%20Z%201%20F
Posted: Sun Jan 18, 2015 11:26 am
Author: Z1parR
Hi John , i've got Road Riders on my Z1B .
Settled for 32 front and 36 rear .
Can touch the right footrest down in moments of madness
Posted: Sun Jan 18, 2015 4:48 pm
Author: andyb1962
I ran Avons on thou at higher pressures though
No issues.!
Posted: Sun Jan 18, 2015 5:22 pm
Author: Pigford
Z1parR wrote:Hi John , i've got Road Riders on my Z1B .
Settled for 32 front and 36 rear .
Can touch the right footrest down in moments of madness
I heard you even got both feet down once, too
So how long do these BT45's last (mileage) at the higher psi figures
With such narrow sections do they wear quick
Posted: Sun Jan 18, 2015 7:11 pm
Author: Z1parR
I've got BT45s on my Z1R .
Not sure about the mileage but they've lasted two years so far
post
Posted: Sun Jan 18, 2015 7:22 pm
Author: ted1r
Michelin Pilot Active ,32 36.
Ted
Re: Tyres for standard Z1
Posted: Sun Jan 18, 2015 8:26 pm
Author: Bill Newman
ROZZER wrote:
I'm having handling isues on my current tyres (Continental Blitz) running on pressures in owners manual (28 front 32 rear), I think these may be too low for modern tyres but can't get any info.
What are the handling issues?
FWIW - I have run 32/36 on BT45s for 4000miles without issues but the back is now noticeably squaring off. This is not much different to the rear on my ZRX on BT023s which started to square off at 3500 miles.
Posted: Fri Jan 23, 2015 11:08 am
Author: ROZZER
Thanks for all the advice. Ill deffo try higher pressures wen im back in the saddle after latest round of surgery. Handling issues are weaving above 80 mph and wheels tracking road imperfections making bike feel very unstable. Also wiggles its arse over cats eyes yet our kids bike was rock steady ( Z1b on konis and metzelers). Mine is on repro shox ( i know they wont be helping either but want to retain original looks). Not looking for modern handling just an improvement and tyres seemed logical start point after all cycle parts have been renewed. Tyres only done about 3k miles but little wear age could be an issue hence wanting recs on tyres and pressures. Thanks again guys.
Posted: Fri Jan 23, 2015 2:30 pm
Author: KeithZ1R
ROZZER wrote:Thanks for all the advice. Ill deffo try higher pressures wen im back in the saddle after latest round of surgery. Handling issues are weaving above 80 mph ( Z1b on konis and metzelers).
Point 1 good plan......... point 2 eat more pies ............. point 3 you will be hard pressed to better that setup, good luck