Z1OwnersClub GB

Posted: **Sat Nov 08, 2014 5:34 pm**

Guyz does the club have a rotor holding tool for holding rotor steady to torque up the bolt? or does anyone have one i could borrow please? Ta PaulJ

Posted: **Sat Nov 08, 2014 5:43 pm**

Posted: **Sat Nov 08, 2014 6:01 pm**

I've always done this with the engine fitted in the bike.

in gear, assistant with their foot on the back brake and torque it up.

Posted: **Sat Nov 08, 2014 6:04 pm**

Tried that Chris clutch didnt hold it only diff is its a lock up clutch!

Posted: **Sat Nov 08, 2014 6:14 pm**

I use a heavy duty strap oil filter wrench Paul to hold the rotor enough to tighten the bolt. only around Â£9.00 posted on e bay

Posted: **Sat Nov 08, 2014 6:24 pm**

Paul can you measure the outside diameter of the rotor as i did have a genuine one but lent it out & it has not returned

Posted: **Sat Nov 08, 2014 6:56 pm**

Easy enough to make if you have a welder, I made one that fits 650/750 engines.

Posted: **Sat Nov 08, 2014 7:58 pm**

PAULJAC47 wrote:Tried that Chris clutch didnt hold it only diff is its a lock up clutch!

Ah yes...

Posted: **Sat Nov 08, 2014 8:20 pm**

Paul, I'm sure I've got one if you need to borrow

Posted: **Sat Nov 08, 2014 8:28 pm**

Thanks Scott please check,happy to pay post,going to try filter,ratchet wraps tommorow....Ta Paul J

Posted: **Sat Nov 08, 2014 8:49 pm**

Oakey dokey, shout if you need it

Posted: **Sun Nov 09, 2014 4:04 pm**

Sorted made one up from piece of flat steel,checked torque all ok,,,Thanks for advice Guyz

Z thou Rotor holding tool