Z1OwnersClub GB

Hi, Have searched and sent a few p.m.s to the wrong people but looking for advice and contacts on the following please re my a4 resto.

1/ Who is the person that refurbs switches ?
2/ And the same for brake master cylinder ?
3/ Finally any advice for refurbing throttle cables . Was just going to get them rezinced where appropriate but the curved sleeve that goes into switch/throttle is chromed ?

Thanks in advance G

Remember to use STAINLESS bolts, nuts, washers, spacers and spokes!!!

Thanks Jimmock

G,

It's the ONLY way !!!

hi,Mikey did a superb job anodising my z1a master cylinder.

Thanks Steve , getting a box of bits together tom send to Mikey will give him a shout

Buy new throttle cables, bit of a waste of time trying to get that curved sleeve re-chromed. They are a consumable. I do find that curved section is the most rust prone of all the parts on the bike!
RegardZ.

I agree with Garn G, you could spend more having the bits on your cables re zinced and chromed than the cost of new cables. I am sure original kawasaki throttle cables are still available from zpower. Hope your resto is going well mate!
Regards Dave.

Thanks Garm , your assistance is always appreciated.

Ditto Dave . I will be taking you up on your kind offer of assistance when I get my re zincing back , All the Best to you both g

Just giving this a bump to see if anyone can id the guy who refurbs switches ? I am sure he was a GT 750 ( kettle ) owner , cheers g

G, pretty sure the switch resto was undertaken by "Zed man" - send him a PM.

I know him from another forum (Kettleclinick), and he refurbs switches for GT750 also.

Cheers Tim