fuel tap help
Posted: Mon Feb 03, 2014 9:46 pm
decided to try some CV carbs on my z1000ST. Has the 44mm mounting plate.
The fuel tap hits the carb tops.
I know pingel do an offset plate and tap that you can use , but I don't want to spend £100 on it.
Anyone know where I can get a new tap with the following features.
1 Manual tap with on/off/reserve.
2 Male fitting to tank ( not bothered which thread, can cut the adapter plate to suit)
3 Enough flow for a standard z1000 engine
4 REAR facing fuel outlet
5 Ethanol proof
6 low profile
The fuel tap hits the carb tops.
I know pingel do an offset plate and tap that you can use , but I don't want to spend £100 on it.
Anyone know where I can get a new tap with the following features.
1 Manual tap with on/off/reserve.
2 Male fitting to tank ( not bothered which thread, can cut the adapter plate to suit)
3 Enough flow for a standard z1000 engine
4 REAR facing fuel outlet
5 Ethanol proof
6 low profile
