Page 1 of 1
rear sprocket nuts
Posted: Sat Dec 07, 2013 4:11 pm
Author: Redbeard
I've got a shiny new Talon sprocket and I'd like to replace the tired looking sprocket nuts, can someone confirm the thread size for me please? Also, will I need to use the retainer washer thingy's cos they look worn out too? Cheers!
Posted: Sat Dec 07, 2013 4:56 pm
Author: njwmct
Not sure what the thread size is but scrap the crappy tab washers & use some flanged self locking nuts - a much better engineered solution..
I used a set from a Suzuki GSXR1000 which were the correct thread & look so much better.
Posted: Sat Dec 07, 2013 5:20 pm
Author: jimmock
And remember, they MUST be stainless.
I'm almost certain they are M12 FINE. (M12x1.50)
Posted: Sat Dec 07, 2013 8:38 pm
Author: Redbeard
Thanks gents.
Posted: Sat Dec 07, 2013 10:05 pm
Author: KeithZ1R
Not wishing to contradict James but i'm pretty sure their M10 x 1.25
Posted: Sun Dec 08, 2013 12:21 am
Author: jimmock
KeithZ1R wrote:Not wishing to contradict James but i'm pretty sure their M10 x 1.25
Keith,
I did actually ponder with that for a few seconds.
I KNEW they were fine, but couldn't remember if they were 10 or 12mm.
Being on the boat, I couldn't "nip out" to check!!!
But I'll accept your apology anyway!!!!!!!!!!
Posted: Sun Dec 08, 2013 4:50 pm
Author: Al
M10X1.25 on the back wheel of the J.
AL
Posted: Sun Dec 08, 2013 7:40 pm
Author: ADRIAN H
m10x 1.25 on my Z1B and my Z1000A2
Posted: Sun Dec 08, 2013 9:15 pm
Author: Redbeard
Nice one guys, I've ordered some stainless m10 x 1.25's.