Z1OwnersClub GB

Gonna bid on some Z650 forks on fleaBay, as they seem same as Z900?
Anyone know for sure before I commit

I think they are. me last A4 had the lugs on for the mudgaurd stays and most of the ones i looked at were the same. No stays on a A4 but they are on a 650, I think..... couple of other people have said the same,also the fork oil drain holes are not in the middle of the leg. dont hold me to it though but i am 90% sure they fit ok. Iv'e seen A4's with no fork stay lugs aswell. Better shut up now before i get confused

think kh500 is the same also

Cheers chaps, have measured them up against me Z650, but wanted some unbiased opinions, so I'd best get bidding

Same as Kirby Trouser press 74-76 but only single disc fitment

Jack, see u Sat

You sure will so don't forget my laundry.
It was a full service wash with the premier press service

Looks like the Z650-B1 is the same as the Z900 and the other models mentioned. The Z650-B2 is different. At least by P/N.

Diameter is the same but they are shorter in length.

Pigford wrote:Cheers chaps, have measured them up against me Z650, but wanted some unbiased opinions, so I'd best get bidding

A guy in work broke a z650 for spares for his, will ask what he has left (when I see him), and get back to you.....

UPDATE......prob' no good this is his reply.................

I?ve a complete set of forks in need of some TLC. Off the top of my head
the stanchions need re-chroming and replacement fork seals, plus a damn good clean and polish of the lower legs. If you like I?ll take some snaps and e-mail them.......
Think he means F*@ked, is that the same as TLC ??..