Z1OwnersClub GB

Hi all,
I have now totally stripped my Z1000 motor, split the case"s etc, one of the 6mm bolt broke off, fortunetly I manage to get the broken bit out without to much trouble, phew.anyhow after that, I decided I would not reused any of the original case bolts as I do not trust them, and will renew them, the m6 and m8"s, I cannot decide which way I should go, either 8.8 zinc plated or higher? or maybe stainless a4-80?
so just wondered what you guy though or do and have done....

stainless,and aliuminium,dont go well together.

You can buy complete M6 case bolt kits from either Debbens and Zpower or maybe from both I think.

Use the APE stud kits for the M8's.

inox in southampton which must be local to you. Do a variety of different finishes. migght be worth popping around and have a chat.

http://www.inoxbolt.co.uk/zen/