Page 1 of 1
coil mod
Posted: Sun Sep 22, 2013 5:08 pm
Author: royboy
hi all having problems with mod wired up as per instructions but with kill switch in off i'am getting power and when in run there is no power,
I have electronic ignition boyer bronsden not dyna s.do I have to some thing
to that,only getting 9.46 at coils before.
Posted: Sun Sep 22, 2013 5:33 pm
Author: z1bman
what colour wire from the kill switch have you connected to terminal 86 of the relay?
mod
Posted: Sun Sep 22, 2013 8:09 pm
Author: royboy
hi z1bman
put the wire to the yellow wire from one of the coils.
Posted: Sun Sep 22, 2013 8:18 pm
Author: z1bman
is the other coil still connected to the yellow/red wire ?
Posted: Sun Sep 22, 2013 8:36 pm
Author: royboy
hi no main wire disconnected,and new wire to 87 is connected
Posted: Sun Sep 22, 2013 8:44 pm
Author: z1bman
85 on the relay should be earth + 30 should positive fuse protected
Posted: Sun Sep 22, 2013 8:51 pm
Author: royboy
hi that is what I have got
Posted: Sun Sep 22, 2013 9:00 pm
Author: z1bman
disconnect the yellow/red from the relay + see if you lose the 12v feed from this wire when you turn the kill switch of
Posted: Sun Sep 22, 2013 9:11 pm
Author: royboy
will look in the morning
Posted: Tue Sep 24, 2013 6:00 pm
Author: royboy
I have sorted it out now,it was the 5 pin relay for some reason pin 87a was allways live,put 4 pin relay on now all is working as it should.
thanks for the help
Posted: Tue Sep 24, 2013 7:20 pm
Author: KeithZ1R
royboy wrote:I have sorted it out now,it was the 5 pin relay for some reason pin 87a was allways live,put 4 pin relay on now all is working as it should.
thanks for the help
5 pin relays are normally "changeover" units they have a common, normally open and normally closed and two connections for the coil
