Z1OwnersClub GB

I'm about to torqe the head down on the eddie lawson. Bolts 13 and 14 are 10mm bolts on the out side of the block. Are these torqued down to the same settings as the rest of the head bolts?

I've torqued everything down to 18 the next step is 29 which seems a little over the top for a 10mm bolt and i dont realy want one to snap off

Regards

Chris

Muddychris , The two outer bolts 6mm thread 10mm head on Z1s are torqued to 104 ins-lb {1.2 Kg-M} and Cylinder head nuts are 25 ft-lb {3.5 Kg-M}. Hope that is some help.

in lbs x .0833 = ft-lbs


104 x .0833 =


8.6 ft-lbs