Z1OwnersClub GB

Posted: **Wed May 01, 2013 6:19 pm**

Has any one put a decent thread with pics about raising or lowering the needle in the carbs,have searched but not found to much
Any help please

malc

Posted: **Wed May 01, 2013 6:45 pm**

IT SHOWS HOW TO DO IT IN THE WORKSHOP MANUAL

Posted: **Wed May 01, 2013 8:14 pm**

Wired George he's helpful :wink:

[url]

Posted: **Wed May 01, 2013 8:31 pm**

The difficult part is removing the two philip head screws from under the slide to expose the circlip that locks in the needle position.
Can't find a decent thread on this procedure... Agree with others ... workshop manual or WiredGeorge.
RegardZ.

Posted: **Wed May 01, 2013 10:53 pm**

Does any one in the uk do a similar service to wired george

Thanks

Posted: **Thu May 02, 2013 6:25 am**

Malc, have a look at <http://www.vintagebikeforum.org/>.
This is run by Wired George and he answers most questions.
You will probably find an expert in UK, however, it's good to find out a bit before you go to the carb mechanic.
RegardZ

Z1OwnersClub GB

Early Z1a Carbs

Early Z1a Carbs

carbs