Page 1 of 1
Starter clutch
Posted: Tue Jan 29, 2013 8:23 pm
Author: Z1B Alan
I need to investigate my Z1B starter clutch and therefor require a bolt to remove the rotor. I am aware the steering stem and rear spindle bolts fit but these are both chromed and so I don't want to damage them. I believe the bolt is m16 but I dont know the pitch can anyone give me the correct pitch and any tips for the removal of the rotor.
Cheers
Alan
Posted: Tue Jan 29, 2013 9:04 pm
Author: Keefleaf
Try using the Kawasaki bolts but put a piece of wood over the end before you hit it.
P.S. the Std bolts are tapered so you don't F'k the thread.
Posted: Tue Jan 29, 2013 9:14 pm
Author: Z1parR
I could have a non too pretty steering stem bolt dropped off in Ewloe that you can use Alan ?
Posted: Tue Jan 29, 2013 9:26 pm
Author: KeithZ1R
if you use the stem bolt put a suitably sized ball bearing against the shaft end first and forget about whacking it lock everything up and use a big lever on the socket
Posted: Tue Jan 29, 2013 10:02 pm
Author: zed1015
Yes ! don't whack the extractor bolt, it can weaken the rotors magnetism.
Posted: Tue Jan 29, 2013 10:06 pm
Author: KeithZ1R
and if your really unlucky the feckin things will fall apart
Posted: Wed Jan 30, 2013 3:53 am
Author: zmaxmotorsports
KeithZ1R wrote:if you use the stem bolt put a suitably sized ball bearing against the shaft end first and forget about whacking it lock everything up and use a big lever on the socket
Exactly
