Page 1 of 1
diameter of clutch rod ball
Posted: Thu Jul 12, 2012 9:10 pm
Author: nanno
Could someone measure the diameter of the clutch rod ball that sits in the clutch basket and let me know... seems like mine is now hiding somewhere in the darkest darkness under the workbench or under the lathe...
Cheers,
Greg
Posted: Thu Jul 12, 2012 9:51 pm
Author: steve bowdler
Posted: Fri Jul 13, 2012 10:25 am
Author: nanno
That's 9.5mm in metric money!
Hmm, a trip round to the bearing shop is due, I'd say.
Posted: Fri Jul 13, 2012 5:07 pm
Author: Hack
If you really want to find the original that you dropped in your workshop, just switch out the lights and walk around bare foot with a Ming vase in each hand.
You should locate it in a matter of seconds!
Andy
Posted: Sat Jul 14, 2012 7:56 am
Author: Pigford
Posted: Sat Jul 14, 2012 7:59 am
Author: nanno
Lovely tip...unfortunately it probably rolled somewhere towards the lathe, so there's tons of small stainless steel chips on the ground. Not exactly sure, whether I want to pick all of them up like that.
(No worries, I know it was a joke)
Posted: Mon Jul 16, 2012 8:15 pm
Author: 750steve
Hack wrote:If you really want to find the original that you dropped in your workshop, just switch out the lights and walk around bare foot with a Ming vase in each hand.
You should locate it in a matter of seconds!
Andy
hahahahahaha that near made me spit coffee!!
