Z1OwnersClub GB

Finaly extracted the baffle out of the Kerker after some musing and head scratching oh and a lot of swearing . it finaly relinquished its hold after being persuaded from the header end with a metre length of 25mm round bar and some gravity tapping Lots of loose wadding fell out in bits so suggestions please for a suitable replacement for same it looks and feels like glass fibre

You can get the wadding from any Moto x dealer Keith, I used it on my pipe.http://www.ebay.co.uk/itm/Exhaust-Waddi ... 3f163e7c8b

Thanks guys I knew somebody would know . I luuuv this club

or you could try

http://www.thermalvelocity.co.uk/

Clever packing that comes flat (so it's easy to fit) and then expands when hot (the threads holding the quilt together melt) to fill the can. There's a calculator on the site where you fill in the dimensions of your silencer and it tells you how much you need to put in.

Not tried it yet but I ordered a load yesterday and hoping it turns up quickly as my Millie was measured at 103dB and I'm hoping to take her to Snett on Tuesday where the limit's 102